he is asking if ctr pistons fit on b18a rods in a b18a block

 

B16B pistons are from a P72 block, B18A rods are from a PR4 block... THEY WONT ------ WORK WITHOUT MODDING... just like i said to begin with.



so to recap...

bitchasscracker = idiot that doesnt know wtf he is talking about

B16B pistons + PR4 rods = grinder to get them to fit

 

Yes but it also depends where he gets them, a few of my friends got them from ebay and no need to grind down while others did.

 

shitty aftermarket parts have no quality controls you sure those where actually B16B/PCT pistons and not just PR3's?

 

oh and i bought some of those cheap *** ebay pistons for my homeboys car, we had to grind the ******* to fit.

 

ok I have done this and they do work. but you must shave 1mm off the small end of the ls rod. if you are going to use the b16b/pcts you will be in the 12ish cr and depsite what people say this will run just fine on pump gas with moderate tuning. they really run best with 110+ but will make good power on pump. look to make in the high 190whp to low 200's with a set of regrinds on that setup.

 

thank you for the ebay confermation like i said. seem i do know what i'm talking about, my friend did buy them off ebay and they did fit ls rods.

 

thanks for all of the feedback!!!! thats what makes HMT the ------ ----. Quick answers and the exciting ------- ---- talking.......

 

hahahahah ------ nogs....... got the pct pistons to go in to the pr4 rods with no mods.....just letting yall know what going on!!!!

 

are they original Honda parts?
Negative