does anybody know if you can swap these out for other injectors? my buddy needs a new primary on his dpfi sedan and its obd0 while the spare injectors i have are from a y7. i just want to know if i could swap one in and he'd be fine? anybody ever done this before?

****UPDATES****
ok found out 1 of the pins popped out of the primary injector. i fit it back in and now code 16 is gone.
now the ecu throws no codes.
the car wont ideal for ---- and shuts off unless someone has thier foot on the gas...holding it at 1200 or so rpm.
it spits and sputters and shuts off in no time. sometimes it will run for a few seconds or couple minutes then just die slowly.
also when the rpms get below 1000rpm, the battery light comes on.
now im thinkin its the alternator going out judging from ^^^.

i dunno, it drive me just as nuts as him..........

 

never heard of it done other than adding an extra injector on the intake piping.

 

So he just has a bad injector? not trying to turbo or anything?

 

yeah a bad primary injector. the car runs and drives, but has absolutely no power until after 2500rpm. once the secondary injector takes over the duties it gets stupid. it spits and sputters and hes using way to much gas in to short of time. its the only code his ecu is throwing.

 

have you looked at the DPFI injectors and noticed the different size of said injector?

 

what code is it throwing? one of the injector codes says too check gounds and ----

 

throw a dsm 450 in there












































lol

 

codes for injectors are usually wiring



I have never seen a code for a bad injector they just take a dump and make your car get 4 mpg



I have never even really looked at the dpfi injectors they go in the trash can along with the rest of the toilet bowl manifold



if they look the same ---- it give it a try if it runs lke *** you have your answer



go to j yard and get dpfi injecotr

 

might be doing a dpfi swaop this weekend, if I do I will send the the primary

 

that would be nice TJ, where ya been havent seen ya on in a while or talked to ya?

im hitting up the junkyards tomorrow to see if i can try my luck and run across one. in my area, imports are few in far. hopefully ill get lucky. i will also look at his wiring because what you said chris. funny, even after about 10 years of working on cars. its only been about 2 since i've owned a honda and im still learning about these things. lol :P,