Okay so i got hasty because all the tuts said match colors and connect the wires/re-pin into new plug. Well I de-pinned my plugs and went to match wire colors and pretty much none of the wires match color.

The engine harness is the stock 91 civic standard harness
the distributor is a td-02u from a 91 si
I am running a pm6 ecu

distributor wire colors...
blue
blue w/yellow stripe
yellow w/ green stripe
white
creme
creme w/blue stripe
white w/ blue stripe

engine harness colors and my c1 and c2...
c1
c2
orange
orange w/ blue stripe
white w/blue stripe
big white
little white

I take it that the creme color is supposed to be orange

so...
dizzy-----------------------------------harness
creme----------------------------------orange
creme w/ blue ----------------------orange w/ blue
white w/ blue ------------------------white w/ blue
blue w/ yellow -----------------------c2

after that i am lost. i have these left to connect
dizzy...................................harness
yellow w/ green.....................c1
blue.....................................big white
white...................................little white

Now are my assumed connections right and what about the rest of the connections. all tuts say c1 goes to a blue/green wire and my distributor does not have that color.

Now after searching a while I found this picture of the plugs and had I not de-pinned my plug already this would have made it simple just going by position rather than color.

 

anybody have any idea how to wire it up?

 

your color wires should match up there only one different one which is the big white did swap on my car ill check and get back to you